在线亚洲激情-在线亚洲欧美-在线一区观看-在线中文-在线中文字幕不卡

熱門搜索:儀器儀表,云平臺,解決方案
產品分類

Product category

技術文章 / article 您的位置:網站首頁 > 技術文章 > 安科瑞交流電表在保加利亞光伏系統中的應用

安科瑞交流電表在保加利亞光伏系統中的應用

發布時間: 2022-12-08  點擊次數: 730次

安科瑞 繆凱倫

ACREL AC energy meter’s Application in PV system in Bulgaria

摘要:本文介紹了安科瑞APM系列交流電表在保加利亞光伏系統交流側的應用。主要用于光伏系統中的電流的計量,配合互感器對電路系統進行計量、通訊和控制等。

Abstract: This paper introduces the application of ackry APM series AC meter in the AC side of Bulgarian photovoltaic system. It is mainly used to measure the current in the photovoltaic system, and cooperate with the transformers to measure, communicate and control the circuit system.

1.項目概述Project Overview

該公司位于保加利亞,公司主要在保加利亞及周邊國家從事小型光伏發電中心項目的設計/安裝施工/維護等業務。客戶想要使用交流電表APM801、APM810等和互感器,用于光伏系統交流側電流電壓的監測計量、通訊以及利用APM電表的開關量功能進行控制。

The company is located in Bulgaria. The company is mainly engaged in the design / installation, construction / maintenance of small photovoltaic power generation center projects in Bulgaria and surrounding countries. The customer wants to use AC meters apm801, apm810 and mutual inductors for monitoring, metering and communication of current and voltage at the AC side of photovoltaic system, and control by using the switching value function of APM meter.

2.APM系列儀表簡介APM Series Energy Meters

ACREL的APM系列功率表是根據IEC標準設計并與技術同步的功率表。

APM系列電能表具有全功率測量、電能統計、電能質量分析和網絡通信等功能,主要用于供電網絡質量的綜合監測。

本系列儀表采用模塊化設計,具有豐富的外部DI/DO模塊、AI/AO模塊、帶T-Flash(TF)卡的事件記錄(SOE)模塊、網絡通信模塊、溫濕度測量模塊功能,可實現電路全功率測量和開關狀態監測,具有以太網接口的雙RS485可實現RS485主站的數據拷貝,無需進行數據交換。PROFIBUS-DP接口可實現高速數據傳輸和聯網功能。

APM series power meters of ACREL are power meters that are designed according to IEC standards and synchronized with international advanced technology.

APM series meters have full power measurement, energy statistics, analysis of power quality and network communications and other functions, are mainly used for comprehensive monitoring of the quality of power supply network.

This series of meters use a modular design, with a rich function of the external DI / DO module, AI / AO module, event recording (SOE) module with T-Flash (TF) card, network communication module, Temperature and humidity measurement module, can achieve full power measurement of electrical circuit and monitoring of switch status, Dual RS485 with Ethernet interface can realize data copying of RS485 master station, eliminating the need for data switching exchange. PROFIBUS-DP interface can realize high-speed data transmission and networking function.

3.型號及功能介紹Type and Function Description



image.png

image.png

4. 技術參數Technical parameters

Table 2 technical parameter descriptions

image.png

image.png




5.客戶特殊需求  Requirements from Customer

電網供應商要求:

(1) 監控電壓:L1-N、L2-N、L3-N。非標稱 = 230V

(2) 過壓時切換繼電器輸出。分為兩步,

    1 步:110% 非標稱或 253V - 延遲 60 秒(s);

   2步,115% 的非標稱或 264V - 延遲 0.1s;設置范圍: U:非標稱的 100-140%,未列出步驟,可能是 1V 或 1%;延遲0.05s 到 60s,未列出步驟,可能 1s;      

(3) 欠壓時切換繼電器輸出:

第①步;非標稱電壓或 184V 的 80% - 延遲 0.2s;設置范圍: U:非標稱電壓 10-100%,未列出步驟,可能是 1V 或 1%;延遲0.05 s 到 3s,步驟未列出,可能為 1s;

(4) 過頻時切換繼電器輸出:

   第①步; 50.5Hz——延遲0.1s;設置范圍:F:50-52.5Hz,step 0.1Hz;延遲

(5) 超頻時切換繼電器輸出

(6) 恢復延遲。由于先前的一些原因,當DO打開時,在網格參數回到標稱范圍后應該有時間延遲。時間范圍1-60秒,step 1秒

(7) 附加設置。(如果可能的話)。

  7.1.當非標稱值低于60-70% 時,可禁用低頻和超頻監測;

  7.2. 當發生超頻/低頻時 -- DO不應該自動恢復,它應該等待手動/遠程等方式恢復。

terms of reference from grid supplier:

1)monitoring voltages: L1-N, L2-N, L3-N. Unominal = 230V;

2)switching relay output at overvoltage: 2 steps:

Step 1: 110% of Unominal or 253V - delay 60 seconds (s) ;

Step 2: 115% of Unominal or 264V - delay 0.1s;

3)switching relay output at undervoltage:

1-step; 80% of Unominal or 184V - delay 0.2s; Range of settings: U: 10-100% of Unominal, step not listed, maybe 1V ot 1%; Delay: 0.05 s to 3s, step - not listed, maybe 1s;

4)switching relay output at overfrequency

1-step; 50.5Hz - delay 0.1s; Range of settings: F: 50-52.5Hz, step 0.1Hz; Delay: 0.1-0.5s, step - maybe 0.1s;

5)switching relay output at overfrequency

1- step; 47.5Hz - delay 0.1s; Range of settings: F: 47.5-50Hz, step 0.1Hz; Delay: 0.1-0.5s, step - maybe 0.1s;

6)Delay for recovering. When DO is on by some of previous reasons, there should be time delay after grid parameter(s) are back in nominal range(s). Time range 1-60s, step 1s

7)Additional settings. (If they are possible).  

7.1 When Unominal is lower than 60-70%, under and overfrequency monitoring can be disabled

7.2 When overfrequency/underfrequency is happened - the DO should not be recovered automatically, it should wait for some kind of manual/remote restore.

上述7點為客戶對所采購產品的特殊需求,除第七點中部分要求不能滿足客戶外,其余需求都能滿足。基本完好解決了客戶的需求。

The above 7 items are the special needs of customers for the purchased products. Except that some requirements in point 7 cannot meet the needs of customers, other needs can be met. Basically solved the needs of customers.

6.安裝圖片Installation Picture

image.png


參考文獻 Bibliography

1.Solutions For Enterprise Micro-grid System 2021.04



  • 聯系電話電話
  • 傳真傳真0510-86179975
  • 郵箱郵箱2355269602@qq.com
  • 地址公司地址江蘇省江陰市南閘工業園東盟路5號
© 2025 版權所有:江蘇安科瑞電器制造有限公司   備案號:蘇ICP備08106144號-114   sitemap.xml   管理登陸   技術支持:化工儀器網       
  • 公眾號二維碼




蘇公網安備 32028102001250號

主站蜘蛛池模板: 国产成人精品在线观看| 欧美亚洲另类久久综合| 亚洲精品高清国产一久久| 黄色片在线免费播放| 欧美在线观看日韩欧美在线观看| 91精品国产露脸在线观看| 亚洲黄色三级视频| 欧美日韩一区二区三区毛片 | 国产精品视频第一区二区| 麻豆精品久久精品色综合| 亚洲欧美在线免费观看| 一级做a爰片性色毛片新版的| 成年黄色| 欧美日韩亚洲国产精品一区二区| 国产激情视频在线| 国产精品视频全国免费观看| 欧美人成人亚洲专区中文字幕| 一级一级 a爱片免费视频| 日韩在线1| 色偷偷亚洲女人天堂观看欧| 国产精品88| 99久久99这里只有免费的精品 | 成人午夜在线播放| 日本一级α片| 亚洲精美视频| 中文乱码视亚洲| chinese麻豆自制国产| 毛片中文字幕| 在线观看日韩一区| 国内自拍亚洲| 美女大黄大色一级特级毛片| 国产精品久久久久激情影院| 日韩中文字幕视频| 日本中文字幕不卡在线一区二区| 极品精品国产超清自在线观看| 国内黄色精品| 国产片一级毛片视频| 浮荡视频在线观看免费| 国产精品无码久久av| 精品国产自在2o18| 日韩国产欧美视频|